1. If possible remove the object causing the puncture.
  2. For best results try and position the puncture at the base of the wheel and deflate completely
  3. Remove the red safety seal and screw the connector tightly on to the tyre valve.
    (In cold weather warm the Tyreweld can in your hands or over the car heater vent).
  4. Place Tyreweld upright and turn the red knob to ‘ON’.
  5. Allow Tyreweld to empty completely then turn the red knob to ‘OFF’.
    Unscrew the connector and retain the can.
  6. Drive immediately for 6-12 miles at a maximum speed of 50mph to fully seal the puncture.
  7. Check and adjust tyre pressure as required.